BILT HAMBER TOUCH-LESS V2 ACTIVE SNOW FOAM

people are viewing this right now

Sugar-based snow-foam pre-wash. SAFE on Coatings and Synthetic waxes!

Out of stock
Notify me when available

    Back in stock alert

    We will send you a notification as soon as this product is available again.





    • Free shipping on orders over 250€
    • Delivery in: 3-7 Working Days

    EXTERIOR WASH ACCESSORIES PACKAGE

    Original price was: €220.00.Current price is: €198.50.
    293.50
    For 2 item(s)
    Out of stock

    TOUCH-LESS is our new eco-friendly pressure-washer, pre-clean, snow foam which can be applied by pump spray or trigger too. Applied at between 0.5% – 2% PIR this bio-degradable sugar-based product provides truly exceptional levels of cleaning of automotive paintwork. Unlike other petrochemical-based cleaners TOUCH-LESS is free-and-easy rinsing, easing the effort of subsequent bucket washes and massively helping post-treatments bond too. TOUCH-LESS also contains corrosion inhibitors. Packed in a 1 litre bottle, contains no phosphates, solvents, NTA, or caustic soda.

    TOUCH-LESS is designed to allow for superior and simple application of our new paint protection product TOUCH-ON.

    SAFE on Coatings and Synthetic waxes.

    Weight 1.2 kg
    SIZE

    1L

    PURPOSE

    PRE WASH

    BRAND

    BILT HAMBER

    Features

    • Touchfree
    • Biodegradable/Eco friendly
    • Sugar-based
    • Dilutable/Economical
    • Powerful
    • Against corrosion
    • MADE IN UK

    How To Use

    • TOUCH-LESS may be applied with trigger spray, pump spray, pressure washer, or snow foam lance. The minimum recommended dilution rate should be 0.5% PIR (Panel Impact Ratio) and up to 2% for very dirty vehicles.
    • It is not necessary to use all diluted touch-less in one wash. One litre of diluted product should last 4-5 washes. Apply to cool panels in shaded conditions. Do not allow this product to dry in use. Keep the bottleneck and lid clean.
    • Where application is through foam cannon or pump spray, the dilution calculation is easy to achieve, however, for application with pressure equipment it is essential to determine the amount of water being delivered to the equipment reservoir.

    Step 1

    Fill the detergent bottle or reservoir (on machine or lance) up to capacity with plain water. Turn detergent feed to full. Take a large bucket or container and discharge the lance into this, watching the detergent bottle until empty. Once empty, stop.

    Step 2

    The following calculations will achieve 4% dilution; Measure the total amount collected and multiply this number by 0.04 (Total can be measured in either volume with a measuring jug or by weight) this is the amount of TOUCH-LESS to use.

    Step 3

    Add the calculated amount from STEP TWO to the pressure-washer reservoir and top up to full with cold water and shake in for a few moments.

    Step 4

    Apply touchless to the entire vehicle or panel by panel. Allow to soak for 1-5 minutes (but never allow to dry). Power-wash off.

    Safety Information

    SAFETY DATA

    • Avoid direct sun
    • Do not use on hot paint
    • Never allow it to dry
    • Wear protective gloves

    You may also like…